Page 2 of 2

Re: Air rifle scope?

Posted: 17 Sep 2016, 15:17
by snoopy
weirach have an arrester block thet has two screws going down, on top of the cap end between the dovetails are two 'holes' put one screw in there and one to lift outside the whole at the back,the lifter placed at the front the screw in the hole may brake..on higher powered guns.(snug fit them together)

get a one peice mount.

cut some slithers of very good quolity electrical tape and place in the dovetails..then gently tweek up tight a bit on each screw at a time.

and...take the scope strain lol.

if they still go out the scope aint up yo it, and come to think of it i remember a similar exsperience that turned out yo be the return flange was about to break inside the tube....time will tell spose.

Re: Air rifle scope?

Posted: 17 Sep 2016, 15:19
by snoopy
...

Re: Air rifle scope?

Posted: 17 Sep 2016, 15:19
by snoopy
double post