Page 1 of 1

DIY Thermal Clip On

Posted: 19 Nov 2017, 21:17
by hardi
Hello all,

There are a lot of very good digital night vision solutions in this forum. Very nice!
But does anyone tried to build an thermal clip on? I mean such as the Pulsar Core or some Armsights version?

If there is already a discussion about that, please let me know!

Thanks a lot
Regards

If there is a thread about it

Re: DIY Thermal Clip On

Posted: 19 Nov 2017, 23:03
by phoenix
Been there and done it - spotters and thermal scopes.
Forget thermal and digital NV front add-ons, the display resolution is too low to allow the use of much scope magnification.
viewtopic.php?f=43&t=9609
viewtopic.php?f=43&t=12281
You'll find it very hard to build a decent DIY thermal for less than equivalent performance commercial equipment

Cheers

Bruce

Re: DIY Thermal Clip On

Posted: 21 Nov 2017, 06:49
by hardi
Thanks Bruce! I will drop you an PN!