Yes mate - Private message sent.Farmer wrote:Do you take paypal ?
QwikFit Add On rigs.
- some bloke
- NON EMMET
- Posts: 9433
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Would this set up fit a hawke eclipse?
Thanks
Alex
Thanks
Alex
- some bloke
- NON EMMET
- Posts: 9433
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
It should fit if yours doesn't have an IR module on the eyebell, assuming the eyebell diameter is the same as most other recent Hawke's at 43mm.Dobbo78 wrote:Would this set up fit a hawke eclipse?
Thanks
Alex
If it does have one I very much doubt it will slide on fully.
-
- Posts: 20
- Joined: 24 Oct 2013, 04:32
- Location: DEVON
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Have sent pm about possible purchase.
-
- Posts: 7
- Joined: 14 Aug 2017, 07:41
- Location: West midlands
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Hi do you sell the bit that just goes on to the scope front which holds the camera, collet chuck?
Also how does the button which controls the modes work?
Thank you
Also how does the button which controls the modes work?
Thank you
- some bloke
- NON EMMET
- Posts: 9433
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Sorry - I am currently very short of them and need to retain the remaining one's for my own builds.Haroon.Shaukat wrote:Hi do you sell the bit that just goes on to the scope front which holds the camera, collet chuck?
Also how does the button which controls the modes work?
Thank you
- some bloke
- NON EMMET
- Posts: 9433
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Double post.
Last edited by some bloke on 20 Dec 2017, 18:25, edited 1 time in total.
-
- Posts: 7
- Joined: 14 Aug 2017, 07:41
- Location: West midlands
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
No worries, do you make them yourself?
Love your build and I'm thinking of purchasing one! It is very neat and compact.
And sorry to ask about the mode switch again but I've asked the question in another section of the forum but no one has replied.
How does it work? I know half push will change the mode but how exactly? Does half a push stop power to PIL driver for just long enough so that when it comes back on it goes on to next mode? And if it stays on that mode for long enough then it will come back on to same mode as it was on before being switched off?
Love your build and I'm thinking of purchasing one! It is very neat and compact.
And sorry to ask about the mode switch again but I've asked the question in another section of the forum but no one has replied.
How does it work? I know half push will change the mode but how exactly? Does half a push stop power to PIL driver for just long enough so that when it comes back on it goes on to next mode? And if it stays on that mode for long enough then it will come back on to same mode as it was on before being switched off?
- some bloke
- NON EMMET
- Posts: 9433
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Correct - same as the lo/med/high modes in torches.Haroon.Shaukat wrote:No worries, do you make them yourself?
Love your build and I'm thinking of purchasing one! It is very neat and compact.
And sorry to ask about the mode switch again but I've asked the question in another section of the forum but no one has replied.
How does it work? I know half push will change the mode but how exactly?
Does half a push stop power to PIL driver for just long enough so that when it comes back on it goes on to next mode?
And if it stays on that mode for long enough then it will come back on to same mode as it was on before being switched off?
Yes, memory mode exists after three seconds.
I have the scope adaptors custom made in small batches to my requirements - as are the 5" monitor boxes, lens adaptors etc.
General information: I busy myself with other things during the summer when there is little demand for night vision and I carry less camera's etc: So please expect a turn around of about 7~10 days after payment received for a few more weeks yet.
Re: KwikFit Add On Night Vision rigs - reduced prices for 2017
Hi Dave ,i would like to order a Kwikfit Evo with a T50ir pill price--£260-00
atb brian
please send payment details for bank transfer
atb brian
please send payment details for bank transfer