DIY NV build Hi from Holland
Posted: 15 Dec 2015, 10:35
Hi guys,
Daan here, over from the Netherlands
I'm an enhousiastic airgunner and petrolhead, like to wrench on cars, streetbikes, dirtbikes, nitrocars, aso...
You could guess that shooting airguns, they also being wrenched on and this time it's my Spa P12 .22. From the photo's you can tell it isn't standard anymore, but long story short:
I was searching the net for info on how to build a nice, diy NV setup. I came across some good infotainment videos on YouTube and picked out what I liked and build a device myself. On the way, registered myself here and like to post what turned out of it (and gather some more info offcourse
)
This is how it looks like when I finished it yesterday:
For so far the introduction. I have few questions whiles I bumped into some issues yesterdayevening. I'll put them in the right section of the board.
Regards,
Daan
Daan here, over from the Netherlands
I'm an enhousiastic airgunner and petrolhead, like to wrench on cars, streetbikes, dirtbikes, nitrocars, aso...
You could guess that shooting airguns, they also being wrenched on and this time it's my Spa P12 .22. From the photo's you can tell it isn't standard anymore, but long story short:
I was searching the net for info on how to build a nice, diy NV setup. I came across some good infotainment videos on YouTube and picked out what I liked and build a device myself. On the way, registered myself here and like to post what turned out of it (and gather some more info offcourse
) This is how it looks like when I finished it yesterday:
For so far the introduction. I have few questions whiles I bumped into some issues yesterdayevening. I'll put them in the right section of the board.
Regards,
Daan
