unfinished broom pro project - Sold

[domi]

Due to and nice hefty bill and various other things going wrong recently I'm having to scrap my broom pro project. I collected everything but the EJ bullet cam and a decent lens.

There's loads of bits included but I'm struggling to get pictures up so will try tomorrow at work. A basic run down is;
V2 viewfinder with battery compartment cut out. Works perfectly
2x18650 battery holder
Hobbyking osd battery level module
Voltage adjuster
30mm tube from some bloke on here
V2 plate that sits at the end of the sun shade by splat
IR T20 with rats tail and figure 8 mount
Various lens adaptors including the sunshade
3 x 18650 nitecore/eagletec

My original intention was to do a broom pro running off two 18650.

I think it would make a good project for some one but not sure if it would be of any interest. But ideally I want to sell the lot in one go.

Any offers are welcome. Should hopefully get some pics up tomorrow.

[gypo]

How much do you want for it mate?
Cheers
G

[domi]

Internet is finally up and running so pictures as promised although a bit delayed...

[domi]

Couple of photos added...

[reaper1064]

Hi mate as per my PM I know you want to sell as a job lot but if you do decide to split then can you let me know.
Cheers.

[domi]

Sorry I cant seem to find any pm's from ya reaper so not sure what's going on there. I've been chatting to one gent on here that's after a few bits so I think splitting might be my only option.

Feel free to pop me another message with what you needed...

[baffled]

Hi there,

If you were to split then I would be up for the v2 eye display if the price were right!

Ken.

[tonyb]

How much are you after for everything
Cheers tony

[domi]

Sorry for the delay getting back to this, V2, sunshade + adaptors and battery holder were all sold an hour ago to reaper. T20 went to a friend.

So just 30mm tube by somebloke to house a EJ bullet cam, voltage adjuster, led push/latch button and osd battery display from hobbyking left.

P.s reaper I pm'd ya but its not getting through..

[reaper1064]

Hi mate it got through,