Swap an SB spotter for a ICOtec remote caller - SWAPPED

[some bloke]

Whilst we are in limbo about the very low cost 5" screen monitor debacle till SURE24 get some guaranteed ones I have found myself overstocked with parts for spotter builds.

For one time only here is a swap deal that saves someone about £100 on one of my SB E700 spotters.

Plan A:

You buy and send me a £180 ICOtec GC500 Remote Programmable Electronic FOX CALL: from Best Fox Call http://www.ebay.co.uk/itm/121474535189

I send you an SB E700 spotter that I sell for £290 now I'm using more expensive monitors in them.


-----------------------------------------------------------------------------------

Plan B:

I also have a Nitetek E700 housing here, and providing Marky can supply me with the other parts to fit it behind your scope I could make a one off combination Marky/SB add-on rig using my battery and screen pod mounting to your scope with an illuminator mount above the pod. There would be a single servo cable plugged into the battery/screen pod to the E700.


First to unconditionally take up either option on this thread gets it - and it is a one off deal unless I can think of anything else I might want to do something similar with.

[thegogg]

If this offer is still available then I'd like to take you up on it Dave . I take it the spotter is complete to include the IR torch mount and handle?

I'll send you a PM with my email address so you can send me your address for delivery of the ICOtec remote caller. Once you email me I'll get the caller ordered for you.

Thanks

Neil

[some bloke]

If this offer is still available then I'd like to take you up on it Dave . I take it the spotter is complete to include the IR torch mount and handle?

I'll send you a PM with my email address so you can send me your address for delivery of the ICOtec remote caller. Once you email me I'll get the caller ordered for you.

Thanks

Neil

That's a done deal Neil.

I have a good few torch mounts so that's OK. I'll email you.