20 tac brass and dies
Posted: 18 May 2015, 17:31
I have 140
Dakota 20 tac brass,
it has been used for load development on my 2 rifles and fired only once, a small amount have been loaded and then not fired, this is seen in the primer pocket as its clean as new.(so have been stripped down for reloading etc.)
been sat in the bag for a while so some will need de-capping, all will need full sizing but no trimming needed.
looking for £110 posted.
I also have a spare set of redding 20 tac dies, light use and they are full size and seating fully boxed but no pin or shell holder. £90 posted for an extra £40 I can throw in a 20 tac body forming die for reworking well used brass/or forming 223 cases to the 20 tac,
Thanks
Bob.
FIRED BRASS NOW £100 POSTED now on hold
20 TAC REDDING 2 DIE SET NOW £70 POSTED
20 TAC BODY DIE £30 POSTED.
Dakota 20 tac brass,
it has been used for load development on my 2 rifles and fired only once, a small amount have been loaded and then not fired, this is seen in the primer pocket as its clean as new.(so have been stripped down for reloading etc.)
been sat in the bag for a while so some will need de-capping, all will need full sizing but no trimming needed.
looking for £110 posted.
I also have a spare set of redding 20 tac dies, light use and they are full size and seating fully boxed but no pin or shell holder. £90 posted for an extra £40 I can throw in a 20 tac body forming die for reworking well used brass/or forming 223 cases to the 20 tac,
Thanks
Bob.
FIRED BRASS NOW £100 POSTED now on hold
20 TAC REDDING 2 DIE SET NOW £70 POSTED
20 TAC BODY DIE £30 POSTED.