Hi, I had some trouble removing the Allen key headed bolts as they had seized in place so I had to drill the allen bit off the top them I could get them off the rifle and managed to unwind the threaded end ok.
Trouble is I can't seem to find details on the size and length of any replacement options.
Anyone able to help me out at all please?
Cheers
Scope screws needed to replace ones on my rimfire scope
-
PESCA
Re: Scope screws needed to replace ones on my rimfire scope
There are quite a few different sizes used.
George
George
-
some bloke
- NON EMMET
- Posts: 9501
- Joined: 27 Jan 2012, 16:14
- Location: Leicester mostly but DEEP S.West sometimes
Re: Scope screws needed to replace ones on my rimfire scope
Most are M4 thread so M4x14 is worth a try first if you have to buy any.
Re: Scope screws needed to replace ones on my rimfire scope
think mine might be 35mm long
-
fizzbangwhallop
- Posts: 2613
- Joined: 18 Oct 2011, 11:27
- Location: north herts
Re: Scope screws needed to replace ones on my rimfire scope
This lot are very good...... once you've an idea of what you need 
http://www.modelfixings.co.uk/index2.htm
Cheers
Fizz
http://www.modelfixings.co.uk/index2.htm
Cheers
Fizz
A correct grip on the butt & cheekweld is imperative for accurate shooting.
Re: Scope screws needed to replace ones on my rimfire scope
sorry, got distracted by your avatar
thanks, will have a nose at the link
thanks, will have a nose at the link
-
fizzbangwhallop
- Posts: 2613
- Joined: 18 Oct 2011, 11:27
- Location: north herts
Re: Scope screws needed to replace ones on my rimfire scope
Hutchey wrote:sorry, got distracted by your avatar
thanks, will have a nose at the link
You're not the only one............I'd like to nose the link too fizz
A correct grip on the butt & cheekweld is imperative for accurate shooting.